Inserting the battery into the v24w phone, Charging and powering the v24w phone, Setting up the v24w phone – NetComm V24W User Manual

Page 8

Advertising
background image

NetComm VoIP WiFi Phone V24W User Guide

Chapter 3: Installing and Using the NetComm
V24W WiFi VoIP Phone




This chapter provides instructions for first-time installation and use of the NetComm V24W
Phone. Firstly, you need to insert the battery into the V24W Phone and then configure it for your
wireless network and VoIP service. After that, you will be able to make and receive Internet
phone calls.

Inserting the Battery into the V24W Phone


To insert the battery, follow these instructions:

1. Remove the battery compartment cover by pressing the silver button and sliding the
battery cover downward.

2. Insert the battery and ensure that the metal contact at the bottom of the battery align
with the metal contact the top of the battery compartment.

3. Replace the battery cover by sliding it upward until it snaps into place.

Charging and Powering the V24W Phone


1.

Plug the USB mini-B connector of the included power adapter into the

USB mini-B port of the IP Phone. Then connect the power adapter to a standard
electrical outlet.

2. The Power LED will flash, alternating between blue and purple. For the initial
charge, allow the battery to charge for at least 10 hours, so the battery will have
a full charge, which is indicated by a solidly lit Power LED. This will maximizes
battery performance and life.

NOTE: When the battery is low on power, it will emit one warning sound or vibration,
unless the Ring Type is set to Silent. (For more information about Ring Types, refer to

Chapter 4: Configuring the V24W WiFi VoIP Phone.”)

Setting up the V24W Phone

1

Press the Power button to turn on the V24W phone

YML873 V24W User Guide - 7

Advertising