NetComm V100 User Manual
NetComm Phones
Advertising
Table of contents
Document Outline
- Contents
- Introduction
- Understanding VoIP
- Minimum System Requirements
- Do I need a Micro filter?
- Package Contents
- V100 ATA Overview
- Front Indicators
- Back Panel
- V100 Start Up
- Resetting the V100 ATA to its factory default settings:
- Installing the V100 ATA
- Before continuing ...
- Option A - Ethernet ADSL Internet Connection
- Option B - Optus/Telstra Cable Internet Connection
- Installing the V100 ATA Utility
- Using the V100 ATA Configuration Utility
- Status Tab
- Connection Mode Tab
- SIP Tab
- Local
- Host
- Phone Configuration
- Proxy and Registrar
- Call Forward
- STUN Tab
- Telephone Book Tab
- Tool Tab
- System
- Diagnostic
- Upgrading the V100's Firmware
- Appendix A: Flow Chart of Configuring V100
- V100 PPPoE Mode
- V100 DHCP Mode
- V100 Fixed IP Mode
- Appendix B: Troubleshooting
- WAN LED is off
- No dial tone
- Fail to register on a SIP server
- Cannot get bi-directional conversation
- Cannot receive any incoming calls
- No DTMF tone at remote site
- Appendix C: Cable Connections
- RJ-45 Network Ports
- Twisted pair cables
- Straight and crossover cable configuration
- RJ11 connector and cable
- 605 to RJ-11 adapter
- Appendix D: Registering your NetComm Product
- NetComm Contact Information
- Appendix E: Legal & Regulatory Information
- Customer Information
- Product Warranty
- Limitations of Warranty