NetComm V100 - Manual (Page 14)

V100 User Guide YML749Rev1
14 www.netcomm.com.au
Option B - Optus/Telstra Cable Internet Connection
Connect the V100 ATA to your Cable modem as illustrated in the following diagram:
Figure 2 - Connecting the V100 ATA to a Cable Modem
Note: You also can connect the V100ATA directly to your cable modem. However, in
this connection other network devices, such as your PC, cannot share cable
modem Internet access.
1.Connect the Phone socket on the rear of your V100 ATA to an analogue telephone using a
RJ-11 cable.
2.Connect the WAN socket on the rear of your V100 ATA to the Ethernet port of your
router/switch using a Category 5 cable.
3.Connect the POWER socket on the rear of your V100 ATA to the power adaptor supplied
and plug into a wall socket.