NetComm IP DSLAM NCT480 - Manual (Page 14)

NCT480 IP DSLAM User Guide YML856 Rev3
14 www.netcomm.com.au
System Management
Operator can provision and manage the NCT480 IP-DSALM through the following system management mode:
CLI – Command line management
LCT – A complete SNMP basis NMS (Element Management System) provides GUI operation under Client-
Server architecture through in-band or out-band IP interface. (This SNMP IP DSLAM management utility is
only applicable to NCT480 firmware R1.43 or older)
Web Management Interface – NCT480 mini IP DSLAM has a web interface for system management. Remote
administration, remote firmware upgrade, system configuration, fault and performance management, system
diagnostics and subscriber loop tests can all be performed be the web management interface of the NCT480
IP DSLAM. Web management is only applicable to NCT480 running firmware R2.0 or later. Web management
of NCT480 IP DSLAM is only compatible under Internet Explorer 6.0 environment.
Changes will be subjected to firmware revision in the future)
Local Management
The NCT480 provide Ethernet interface for CLI connection at local maintenance and operation. An RJ-45 to
DB-9 can be used to connect NCT480 to PC via serial port. The NCT480 can also be locally managed by its
inbuilt web interface through management port Eth-3 with factory default IP address of 192.168.1.1/24.
IP Network Management
The NCT480 provides out-band management thought management Ethernet interface or its GE interface with
proper IP address to associate in the layer 3 network.