NetComm IP DSLAM NCT480 - Manual (Page 22)

NCT480 IP DSLAM User Guide YML856 Rev3
 www.netcomm.com.au
Unpacking the NCT480 System
Each NCT480 system units is securely packaged in a shipping box.
To unpack the NCT480 units, complete the following steps:
1 Inspect the packing containers.
If any damage or other signs of mishandling are evident, inform both the local freight carrier and Turbo
Networks before unpacking. Your freight carrier can provide you with the procedures necessary to file a
claim for damages.
2 Carefully open the box.
3 Remove all packing material.
4 Remove the unit form the box.
5 Open the accessory kits and boxes that contain the cables, documentation, and
management software. Do not use a knife to open these boxes.
verifying Contents
To verify that your shipment is complete, make sure that you received everything on your packing list, and
then compare your packing list to your order. If any items are missing or you need additional information,
contact your local supporter.
Inspecting for Damage
After you verify that all of the equipment is included, carefully examine the assemblies, units and cables for
any damage resulting from shipping. If you suspect any damage form shipping, contact your local freight
carrier for procedures on damage claims.
If you observe any physical defects in the items you ordered, obtain standard warranty service by delivering
the defective part to your local supporter during the applicable warranty period.