NetComm IP DSLAM NCT480 - Manual (Page 21)

YML856 Rev3 NCT480 IP DSLAM User Guide NCT480 IP DSLAM User Guide
www.netcomm.com.au 1
Tools and equipment Required
The Table 3-3 lists the tools and equipment you need to install and remove the NCT480 system components.
Check Tools and equipment
hardware Components
NCT480 System
DC Power Supply
RJ-45 to DB-9 RS232 Console Cable
RJ-21 DSLAM Cables
Software Components
LCT DSLAM Management Utility
(Only Applicable to NCT480 running firmware R1.43 or older; NCT480 running R2.0 or
newer uses web management interface for system management.)
Tools
A 3/16 inch flat-head screwdriver
A Phillips-head screwdriver
Necessary equipment for ESD protection
Mounting screw – To mount the NCT480 system to the rack
Tie wraps
Table 3-3 Installation Tools Lists