NetComm Wireless Access Point NP720 - Manual (Page 46)

Access Point Setup
43
PTP Bridge AP
MAC Address This is not required unless the Bridge Mode is "Point-to-Point Bridge
(PTP)". In this case, you must enter the MAC address of the other AP
in this field.
In PTMP mode,
only allow
specified APs This is only functional if using Point-to-Multi-Point Bridge (PTMP)
mode. If enabled, you can specify the MAC addresses of the APs
which are allowed to connect to this AP. To specify the allowed APs:
1. Enable this checkbox
2. Click the button "Set PTMP APs".
3. On the resulting sub-screen, enter the MAC addresses of the
allowed APs.
Set PTMP APs Use this to open a sub-window where you can specify the MAC
addresses of the APs which are allowed to connect to this AP. This is
only functional if using Point-to-Multi-Point Bridge (PTMP) mode and
you have enabled the checkbox "In PTMP mode, only allow specified
APs".
Parameters
Channel No
• If "Automatic" is selected, the Access Point will select the best
available Channel.
• If you experience interference (shown by lost connections and/or
slow data transfers) you may need to experiment with manually
setting different channels to see which is the best.
Current Channel
No. This displays the current channel used by the Access Point.