Netopia R2121 - Manual (Page 143)

AppleTalk Setup 12-9
Site A has an AURP tunnel to site B. Both sides have multiple zones defined on the EtherTalk por t and a unique
zone on their LocalTalk por ts. If side A has indicated one of its EtherTalk zones is the Free Trade Zone and has
opted to use the Free Trade Zone option for its tunnel to B, then only this Free Trade Zone will show up on side
B and only those machines or ser vices in the Free Trade Zone will be accessible to side B. All of side A will be
able to see all of side B.
Adding an AURP partner
■ To add a new AURP par tner, select Add Partner and press Return to go to the Add AURP Par tner screen.
■ Select Partner IP Address or Domain Name and enter the new AURP par tner’s IP address. If you do not
know the remote network’s IP address, enter its domain name. Domain names are the Internet addresses
favored by people (for example, chagall.ar ts.edu). Domain names are matched to the IP addresses actually
used by IP routers (for example, 163.7.8.202).
■ To initiate a connection with an AURP par tner, select Initiate Connection and toggle it to Yes. This will open
a connection to the remote AppleTalk network after rebooting.
■ You can choose to restrict this par tner to the Free Trade Zone by toggling Restrict to Free Trade Zone to
Yes. See
“AURP Free Trade Zone” on page 12-8 for more information.
■ To add the new AURP par tner, select ADD PARTNER NOW. To discard the new AURP par tner, select
CANCEL.
Modifying an AURP partner
■ To modify an AURP par tner, select Display/Change Partner in the AURP Setup screen and press Return to
display a table of existing par tners.
Use the Up and Down Arrow keys to select a par tner, then press Return to go to the Change AURP Par tner
screen.
Add AURP Partner
Partner IP Address or Domain Name:
Initiate Connection: No
Restrict to Free Trade Zone: No
ADD PARTNER NOW CANCEL
Enter Information about new Partner.