Netopia R2121 - Manual (Page 69)

Easy Setup 7-3
Beginning Easy Setup
To begin Easy Setup, select Easy Setup in the Main Menu, then press Return.
The Easy Setup Profile screen appears.
Easy Setup profile
The Easy Setup Profile screen is where you configure the parameters that control the Netopia R2121’s
connection to a specific remote destination, usually an ISP or a corporate site.
On a Netopia R2121 Dual Analog Router you can add up to 15 more connection profiles, for a total of 16. See
“Creating a new Connection Profile” on page 8-2 .
1. Select Number to Dial and enter the telephone number you received from your ISP. This is the number the
Netopia R2121 dials to reach your ISP. Enter the number as you would dial it, including any required
prefixes (such as area, access, and long-distance dialing codes).
Note: When placing a multi-channel call, the answering equipment must either:
■ be in a “hunt group,” where a single telephone number ser vices multiple lines, or
■ the answering side must implement MP or BAP as a method to advise the calling side what number(s)
to use.
ISPs or corporate IS groups will meet these conditions. For other non-standard dialup connections, you
should verify that one or the other of these conditions is true.
2. To enable address translation, toggle Address Translation Enabled to Yes. For more information on
Network Address Translation, see
“IP Setup, Smar tIP and Network Address Translation” on page 10-1 .
3. Select Local WAN IP Address and enter the local WAN address your ISP gave you.
Connection Profile 1: Easy Setup Profile
Number to Dial: 12345678901234567890
Address Translation Enabled: Yes
Local WAN IP Address: 0.0.0.0
Remote IP Address: 127.0.0.2
Remote IP Mask: 255.0.0.0
PPP Authentication... PAP
Send User Name:
Send Password:
PREVIOUS SCREEN NEXT SCREEN
Enter the directory number for the remote network connection.
Enter basic information about your WAN connection with this screen.