Netopia R2121 - Manual (Page 75)

WAN and System Configuration 8-3
4. Toggle or enter any IP Parameters you require and return to the Add Connection Profile screen by pressing
Escape. For more information, see
“IP Setup, Smar tIP and Network Address Translation” on page 10-1 .
5. If you will be connecting with an IPX remote network, toggle IPX Enabled to Yes, and press Return.
Other wise, accept the default No.
If you enable IPX routing, an IPX Profile Parameters menu item becomes available. Select IPX Profile
Parameters and press Return. The IPX Profile Parameters screen appears.
6. Toggle or enter any IPX Parameters you require and return to the Add Connection Profile screen by pressing
Escape. For more information, see
“IPX Setup” on page 11-1 .
IP Profile Parameters
Address Translation Enabled: Yes
Local WAN IP Address: 0.0.0.0
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
Filter Set...
Remove Filter Set
Receive RIP: Both
Toggle to Yes if this is a single IP address ISP account.
Configure IP requirements for a remote network connection here.
IPX Profile Parameters
Remote IPX Network: 00000000
Path Delay: 10
NetBios Packet Forwarding: Off
Incoming Packet Filter Set... <<NONE>>
Outgoing Packet Filter Set... <<NONE>>
Incoming SAP Filter Set... <<NONE>>
Outgoing SAP Filter Set... <<NONE>>
Periodic RIP Timer: 60
Periodic SAP Timer: 60
Configure IPX requirements for a remote network connection here.