Nortel Networks 8005DC - Manual (Page 75)

Installing and replacing a module 75
Installing a filler panel
If you plan to remove a module from the chassis without immediately
replacing it, you must install a filler panel in the slot.
Procedure steps
Step Action
1 Locate the slot where you want to install the filler panel.
2 If you have an 8010co chassis, insert the filler panel into the slot.
OR
If you have an 8003, 8006, or 8010 chassis, place the filler panel
over the slot.
3 Tighten the two screws with a Phillips screwdriver.
—End—
Installing and replacing a module
This section contains procedures for installing and replacing a module.
You can add or replace a module with the power on or off.
Prerequisites
• The Metro Ethernet Routing Switch 8600 modules are sensitive to static
electricity. Static discharge from your clothing or other fixtures around
you, even at levels that do not create a spark, can cause damage to the
Metro Ethernet Routing Switch 8600 modules.
CAUTION
Electrostatic discharge can damage hardware. Do the
following to protect your equipment from damage.
To prevent static discharge when you work with Metro Ethernet Routing
Switch 8600 modules, place each module on a grounded antistatic mat
until you are ready to install it. If you do not have an antistatic mat, wear
a discharge leash or wrist strap to free yourself of static before you touch
a module. (An antistatic wrist strap is shipped with the 8010co chassis.)
You can also free yourself of static by touching the metal chassis before
you handle the module.
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
Copyright © 2005-2007, Nortel Networks
.