NetComm NB6PLUS4WN - Manual (Page 51)

YML854 Rev1 NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide
www.netcomm.com.au 51
PPP over ATm/ PPP over Ethernet
If the connection type you choose is PPP over ATM or PPP over Ethernet, please refer to the following information.
According to the ISP’s configuration on the server, you can choose PPPoE or PPPoA modes.
Choose PPPoA or PPPoE and click Next.
On this screen, you have to make the settings for WAN IP. To get the IP address automatically, click the Obtain
an IP address automatically radio button. Or click Use the following IP address button and enter the IP
address for WAN interface.
Check Enable NAT if you need.
mTU:
It means the maximum size of the packet that transmitted in the network. The packet of the data
greater than the value set here will be divided into several packets for transmitting.
Type the value into the field of
MTU. The default MTU value for PPPoE is 1492; while for PPPoA is 1500.
Click Next for the next procedure.