NetComm NB6PLUS4WN - Manual (Page 74)

NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide YML854Rev1
4 www.netcomm.com.au
The WAN IP settings page will differ slightly according to the protocol that you choose. This graphic is the one
that you will see if you choose the PPPoE mode in the previous step. You can select
Enable NAT or PPP IP
extension according to your needs. And you can also change the MTU value.
Add Default Route:
Check this item to add a default route.
The next figure following the WAN IP Settings in the PPPoA/ PPPoE mode is shown at the right. You may refer
to the
Quick Setup section for further information.
If you choose IP over ATM from the Connection Type web page, you will get a web page as the figure.
You may refer to Quick Start – Connection Type – IPoA section for more information.