National Instruments PC-DIO-24/PnP User Manual

Page 103

Advertising
background image

Index

PC-DIO-24/PnP User Manual

I-2

©

National Instruments Corporation

mode 1 strobed output (figure), C-13
mode 2 bidirectional bus (figure), C-17
Port C set/reset control words (table), C-5

custom cables, 1-5 to 1-6
customer communication, xiii, E-1 to E-2

D

DATA signal

description (table), 3-11
mode 1 input timing, 3-12
mode 1 output timing, 3-13
mode 2 bidirectional timing, 3-14

digital I/O connector, 4-3
digital I/O power-up state selection,

3-7 to 3-10

high DIO power-up state, 3-7 to 3-8
low DIO power-up state, 3-9 to 3-10

digital I/O signal connections, 3-4 to 3-6

input specifications (referenced to

GND), 3-4

output specifications (referenced to

GND), 3-5

typical digital I/O applications

(figure), 3-6

digital I/O specifications, A-1
digital logic level specifications

input signals (table), A-1 to A-2
output signals (table), A-2

documentation

conventions used in manual, x-xi
National Instruments documentation, xii
organization of manual, ix-x
related documentation, xiii

E

electronic support services, E-1
e-mail support, E-2
environment specifications, A-3
equipment, optional, 1-5 to 1-6

F

fax and telephone number support, E-2
Fax-on-Demand support, E-2
FTP support, E-1
fuse, self-resetting, for +5 V signal, 3-7

G

GND signal (table), 3-2

I

IBF signal

description (table), 3-10
mode 1 input timing, 3-12
mode 2 bidirectional timing, 3-14
Port C signal assignments (table), 3-4

IBFA bit, Port C, C-12, C-18
IBFB bit, Port C, C-12
installation. See also configuration.

jumper W1 location (figure), 2-1
PC-DIO-24 (non-PnP), D-7
PC-DIO-24/PnP, 2-1 to 2-2
unpacking the PC-DIO-24/PnP, 1-7

INTE1 bit, Port C, C-18
INTE2 bit, Port C, C-18
INTEA bit, Port C, C-12, C-15
INTEB bit, Port C, C-12, C-15
INTEN bit, C-7
interrupt control circuitry, 4-2
Interrupt Control Register 1, C-6
Interrupt Control Register 2, C-7
interrupt enable

PC-DIO-24 (non-PnP)

factory settings (table), D-2
jumper settings (figure), D-6
setting, D-6

PC-DIO-24/PnP, C-1

interrupt handling, C-22 to C-23

Advertising