NetComm NB620W User Manual
Page 24
NB620W Super-G Wireless Broadband Gateway User Guide
YML725 Rev1
24
www.netcomm.com.au
PPTP Configuration
Some older modems use a PPTP connection instead of PPPoE. This connection uses a PPP
session to connect to your ISP. After the connection between the ISP and your modem is
established, you are able to use your modem to connect to the Internet.
Host Name/Domain Name. Some ISPs required the host name and domain name as identifi-
cation. If this has not been specified, assign on your own or leave it as blank.
User Name, Password, Confirm Password. Enter your username, password and confirm
again in the fields for the login to the ISP.
Server IP. Your modem's IP address. You must set your computer to be the same domain as
your modem (For example, if your modem's IP address is 192.168.0.1 and the subnet mask is
255.255.255.0, your PC must be configured as 192.168.0.x, where the x is from 2 to 254, and
the subnet mask should be same as the modem's 255.255.255.0). You will be able to access
your modem. Use "ping <your modem's IP>" in the command line of your PC to test your
configuration.. If you don't know the modem's IP address, please refer to the modem's manual
or consult your ISP.