NetComm NB620W - Manual (Page 39)

YML725 Rev1 NB620W Super-G Wireless Broadband Gateway User Guide
www.netcomm.com.au 39
3.2.5 Advanced Setup >> Remote Management
User Name, Password, Confirm Password. You can change the user name and password of
the gateway here. Type in your new user name, then your password and confirm it. Click save
to change the username and password. To increase protection, please use passwords of more
than 6 characters and no simple phrases. After you changed the user name and password, the
gateway will require you to login with the new user name and password immediately.
It is strongly recommended you change the user name and password from the default value to
your own setting when you first access the gateway. The default value is very easy for
unauthorized persons to guess.
Enable Management from WAN port. The remote management feature can be enabled or
disabled by checking this checkbox. When enabled, the user from the Internet can configure
the gateway via the web.
Web Port. The well-known port for web access is 80; if you have your own web site on your
LAN for Internet access, please assign another number that is unique to your virtual server
settings so that other users do not stumble onto your remote WAN management screen.
Allow Management From PC. Check this box to restrict management access from the LAN.
Only the PC with the MAC address you specify here can manage the gateway. If you key in
the wrong MAC address and press "Save" by mistake, your PC will lose access to the gateway.
If this happens, you will need to press the reset button (on the rear side of the gateway) for 5
seconds to restore the gateway to its factory default values.
Send System Log To this PC. The gateway will send the system logs to the PC with the IP
address specified here.