N-Tron 9000 Series - Manual (Page 14)

5/17/2007 page 14 of 138
APPLYING POWER (Side View)
•
Unscrew & Remove the DC Voltage Input Plug
from the Power Input Header
•
Install the DC Power Cables into the Plug
(observing polarity).
•
Plug the Voltage Input Plug back into the Power
Input Header.
•
Tightening torque for the terminal block power
plug is 0.5 Nm/0.368 Pound Foot.
•
Verify the Power LED stays ON (GREEN).
Note: Only 1 power supply must be connected to power for minimal operation. For redundant power
operation, V
1
and V
2
inputs must be connected to separate DC Voltage sources. This device will draw
current from both sources simultaneously. Use 16-28 gauge wire when connecting to the power supply.
Recommended 24V DC Power Supplies, similar to: N-Tron’s P/N NTPS-24-5
•
Input AC 100V…240V
•
Output DC 24V…28V
•
Output Current 5A
•
Peak Current 7.5A for 4 sec.
•
Power 120W
•
Peak Power 180W (max 4 sec.)
•
35 mm DIN-Rail Mountable
•
Dimensions: 1.57”W x 4.88”H x 4.61”D