N-Tron 9000 Series - Manual (Page 99)

5/17/2007 page 99 of 138
Image Loader Commands
Download Image through COM port
Command Name image download
Description To download new firmware image through the serial port on the switch.
Syntax image download
Parameters None
Examples N-TRON/Admin#[1]> image download
NOTES Uses XModem protocol when transferring the file. N-Tron recommends
that you use TFTP or FTP when updating the firmware. TFTP and FTP
are both much faster.
TFTP Commands
Set the TFTP configuration parameter
Command Name tftp set
Description To set the TFTP configuration parameters TFTP Server IP Address and
Remote File name.
Syntax tftp set serverparam <ip-address> <remote-file-name>
Parameters ip-address
TFTP Server IP Address in dotted decimal notation for
establishing the connection to transfer the file.
remote-file-name
Name of the remote file (including complete path) to be retrieved
from the TFTP Server.
Examples eg.1
N-TRON/Admin#[1]> tftp set serverparam 10.1.1.151
flash
eg.2
N-TRON/Admin#[1]> tftp set serverparam 10.1.1.151
/usr/local/tftp/flash
NOTES Please ensure that TFTP ServerIP is a valid IP Address by pinging it.
Show TFTP configuration parameters
Command Name tftp show
Description To display the present values of all the TFTP related configuration
parameters.
Syntax tftp show
Parameters None
Examples N-TRON/Admin#[1]> tftp show
NOTES Displays the Server IP Address and Filename.
Download file from TFTP server
Command Name tftp action get
Description To download a specified file from the TFTP server.
Syntax tftp action get
Parameters None
Examples N-TRON/Admin#[1]> tftp action get
NOTES Check whether the server is up or not
Check that the connection is established.
Check if the file exists or not.
Check the number of bytes downloaded