N-Tron 9000 Series User Manual
Page 33
5/17/2007 page 33 of 138
Ports – Trunking
The Trunking tab under the Ports category displays a list of trunks configured on the switch and the
following details regarding each trunk:
Trunk ID
Trunk Name
Trunk Ports
Trunk State
By selecting the Create button, you can add a trunk group.
NOTE: RSTP must be disabled in order to use the Trunking Feature.
N-Ring Managers cannot have trunking enabled.
A maximum of 4 ports of the same speed can constitute a valid trunk.
Only 1 Trunk per switch can be created.
All trunk ports must be at the same speed and duplex mode. If a port is not linked, there could
be difficulty as to similar speed and duplex mode. It is best to
hard code speed and duplex mode for each trunking link, at both ends.