NEC uPD78056Y - Manual (Page 7)

7
Major Revisions in This Edition
Page Description
Throughout Addition of
µ
PD78052(A),78053(A), 78054(A) to the applicable types
Deletion of
µ
PD78P054Y from the applicable types
Deletion of the following package from the
µ
PD78052, 78053, 78054, 78055, 78056, 78058, 78P058, 78054Y
Subseries:
• 80-pin plastic QFP (14
×
14 mm, resin thickness 2.7 mm)
p. 233 Addition of Figure 9-10. Square-Wave Output Operation Timing
p. 238 Addition of Figure 9-13. Square-Wave Output Operation Timing
p. 296 Addition of Note to Figure 16-4. Serial Operating Mode Register 0 Format
p. 430, 435 Addition of (4) Synchronization control and (5) Automatic transmit/receive Interval time to 18.4.3 3-wire
serial I/O mode operation with automatic transmit/receive function
p. 439 Addition of precaution to 19.1 (3) 3-wire serial I/O mode (MSB-/LSB-first switchable)
p. 444 Change of Figure 19-3. Serial Operating Mode Register 2 Format
p. 446 Change of Table 19-2. Serial Interface Channel 2 Operating Mode Settings
p. 465 Correction of Figure 19-10. Receive Error Timing
p. 474 Addition of 19.4.4 Limitations when UART mode is used
p. 577, 578 Addition of APPENDIX A DIFFERENCES BETWEEN
µ
PD78054, 78054Y SUBSERIES AND
µ
PD78058F,
78058FY SUBSERIES
p. 579 to APPENDIX B DEVELOPMENT TOOL
592 Entire revision: Support for in-circuit emulator IE-78K0-NS
p. 593, 594 APPENDIX C EMBEDDED SOFTWARE
Entire revision: Deletion of fuzzy inference development support system
The mark shows major revised points.