Ricoh Aficio MP 9000 - Manual (Page 47)

Before Sending Files by Scan to Folder
39
2
Sending files to a NetWare server
1. This machine
You can send scan files to NetWare fold-
ers. To send scan files to NetWare fold-
ers, use the NCP protocol.
2. NetWare Server
You can use this server to share files over
the network via NetWare. By sending im-
age data to the server, files can be stored
on the server.
3. Client computer
To download files, a computer must be
running the NetWare client and be logged
onto the server.
Preparation for Sending by Scan to Folder
This section describes the preparations and settings for sending scan files by
Scan to Folder.
Important
❒ Files can be sent to shared folders on client computers.
❒ Files can also be sent to FTP servers if any exist on the network. Files can also
be sent to FTP servers if any exist on the network.
❒ Files can also be sent to NetWare servers if any exist on the network.
A
Connect the machine to the network.
Connect the machine to the network using an Ethernet or IEEE 1394 cable, or
wireless LAN (IEEE 802.11b).
B
Make the necessary network settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine’s IPv4 address and subnet mask
• Specify the IPv4 gateway address
ZZZ511S