ZANKER KBB 24001 SK - Manual (Page 23)

4. Install the lamp cover.
5. Tighten the screw to the lamp cover. 6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Technical data
Dimension of the recess
Height 1446 mm
Width 560 mm
Depth 550 mm
Rising Time 20 h
Voltage 230-240 V
Frequency 50 Hz
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.
Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient
temperature corresponds to the climate class indicated
on the rating plate of the appliance:
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
The appliance must be earthed. The power supply ca-
ble plug is provided with a contact for this purpose. If
the domestic power supply socket is not earthed, con-
nect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electri-
cian.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
Door reversibility
The door of the appliance opens to the right. If you
want to open the door to the left, do these steps before
you install the appliance:
Loosen the upper pin and
remove the spacer.
Remove the upper pin
and the upper door. Loosen the middle hinge.
23