ZANKER KBB 24001 SK - Manual (Page 25)

5 Remove the correct
part from the hinge cover
(E). Make sure to remove
the part DX, in the case
of right hinge, SX in op-
posite case.
E
E
D
C
B
6 Attach the covers (C,
D) to the lugs and the
hinge holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
H
G
7 Connect the appli-
ance laterally to the kitch-
en furniture sidewall:
1. Loosen the screws
of the part (G) and
move the part (G) till
the furniture side-
wall.
2. Tighten the screws
of the part (G)
again.
3. Attach the part (H)
to the part (G).
Ha Hb
Hd Hc
8 Disconnect the parts
(Ha), (Hb), (Hc) and (Hd).
21 mm
21 mm
~50 mm
~50 mm
90 o
90 o
9 Install the part (Ha)
on the inner side of the
kitchen furniture.
Ha
Hc
10 Push the part (Hc) on
the part (Ha).
Hb
Ha
8 mm
11 Open the appliance
door and the kitchen fur-
niture door at an angle of
90°.
Insert the small square
(Hb) into guide (Ha).
Put together the appli-
ance door and the furni-
ture door and mark the
holes.
Ha
8 mm
K
12 Remove the brackets
and mark a distance of 8
mm from the outer edge
of the door where the nail
must be fitted (K).
Hb
13 Place the small
square on the guide
again and fix it with the
screws supplied.
Align the kitchen furniture
door and the appliance
door by adjusting the part
Hb.
Hb
Hd
14 Press the part (Hd)
on the part (Hb).
Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the
cabinet.
Important! If the ambient temperature is low (for
example, in the Winter), the size of the gasket
decreases. The size of the gasket increases when the
ambient temperature increases.
25