Settings required to use scan to folder function, Ethernet – Ricoh Aficio ISC 615G User Manual
Page 34
Connecting the Machine
26
1
Note
❒ In [Effective Protocol], check that the protocol you want to use is set to [Effec-
tive]
.
❒ [LAN Type] is displayed when the wireless LAN interface board is installed. If
both ethernet and wireless LAN (IEEE 802.11b) are connected, the selected in-
terface takes precedence.
❒ When [POP before SMTP] is set to [On], also make setting for [Reception Protocol]
and [POP3/IMAP4 Settings].
❒ When setting [POP before SMTP] to [On], check [POP3] port number in [E-mail
Communication Port]
.
Reference
p.54 “Interface Settings”
p.63 “File Transfer”
Settings Required to Use Scan to Folder Function
This section lists the settings required for sending file.
Ethernet
This section lists the settings required for sending file with ethernet cable.
For details about how to specify the settings, see “Interface Setting” and “File
Transfer”.
File Transfer Setting
Reception Protocol
As required
File Transfer Setting
POP3/IMAP4 Settings
As required
File Transfer Setting
Key Operator's E-mail Add.
As required
File Transfer Setting
E-mail Communication Port
As required
File Transfer Setting
Scanner Resend Time
As required
File Transfer Setting
Scanner Resend Setting
As required
Menu
User Tool
Setting Requirements
Interface Setting/Network Machine IPv4 Address
Necessary
Interface Setting/Network IPv4 Gateway Address
Necessary
Interface Setting/Network DNS Configuration
As required
Interface Setting/Network DDNS Configuration
As required
Interface Setting/Network Domain
As required
Interface Setting/Network WINS Configuration
As required
Interface Setting/Network Effective Protocol
Necessary
Interface Setting/Network LAN Type
Necessary
Menu
User Tool
Setting Requirements