Raritan Computer DOMINION KX II DKX2-0E-E - Manual (Page 145)

Chapter 9: Device Management
131
2. Check the Enable SNMP Logging option; this enables the remaining
SNMP fields.
3. In the Name, Contact, and Location fields, type the SNMP Agent's
(this Dominion unit's) name as it appears in the Dominion KX II
Console interface, a contact name related to this unit, and where the
Dominion unit is physically located, respectively.
4. Type the Agent Community String (the Dominion unit's string). An
SNMP community is the group that devices and management
stations running SNMP belong to; it helps define where information
is sent. The community name is used to identify the group; an SNMP
device or agent may belong to more than one SNMP community.
5. Specify whether the community is Read-Only or Read-Write using
the Type drop-down list.
6. Configure up to five SNMP managers by specifying their Destination
IP, Port #, and Community.
7. Click on the Click here to view the Dominion-KX2 SNMP MIB link to
access the SNMP Management Information Base.
8. Click OK.
Syslog Configuration
Figure 57: Syslog Configuration
¾
To configure the Syslog (enable Syslog forwarding):
1. Check the Enable Syslog Forwarding option to log the device's
messages to a remote Syslog server.
2. Type the IP Address of your Syslog server in the IP Address field.
3. Click OK.
¾
To cancel without saving changes:
Click Cancel.
¾
To reset to factory defaults:
Click the Reset To Defaults button.