Raritan Computer DOMINION KX II DKX2-0E-E - Manual (Page 43)

Chapter 3: Installation and Configuration
29
Step 4: Connect the Equipment
Connect the Dominion KX II to the power supply, network, local PC, and
target servers. The numbers in the diagram correspond to the sections
describing the connection.
Figure 7: Dominion KX II Connections
1. AC Power
¾
To connect the power supply:
1. Attach the included AC power cord to the Dominion KX II and plug
into an AC power outlet.
2. For dual power failover protection, attach the second included AC
power cord and plug it into a different power source than the first
power cord.
Note: If you only attach one power cord, the power LED on the Dominion KX II
front panel will display red because the system is set to automatically detect both
sources. Refer to the Power Supply Setup Page (on page 136) for information
about turning off automatic detection for the power source not in use.