Raritan Computer DOMINION KX II DKX2-0E-E - Manual (Page 154)

Power Control
140
Power Control
Connect the Power Strip
The numbers in this diagram correspond to the steps listed below.
Figure 61: Power Strip Connections
¾
To connect the power strip:
1. Connect the male RJ-45 of the D2CIM-PWR to the female RJ-45
connector on the power strip.
2. Connect the female RJ-45 connector of the D2CIM-PWR to any of the
available female system port connectors on the Dominion KX II
using a straight through Cat 5 cable.
3. Attach an AC power cord to the target server and an available power
strip outlet.
4. Connect the power strip to an AC power source.
5. Power ON the Dominion KX II unit.