Raritan Computer DOMINION KX II DKX2-0E-E - Manual (Page 36)

Step 1: Configure Target Servers
22
Note: If these steps do not work, issue the xset mouse 1 1 command
as described in the Linux command line instructions.
2. Configure the screen resolution:
a. Select Main Menu > System Settings > Display. The Display
Settings dialog opens.
b. From the Settings tab, select a Resolution supported by
Dominion KX II.
c. Click OK.
Note: If you change video resolution, you must logout of the target server and
log back in for the video settings to take effect.
SUSE Linux 10.1 Settings
Note: Do not attempt to synchronize the mouse at the SUSE login prompt. You
must be connected to the target server to synchronize the mouse cursors.
¾ To configure the mouse settings:
1. Select Desktop > Control Center. The Desktop Preferences dialog
opens.
2. Select Mouse. The Mouse Preferences dialog opens.
3. Open the Motion tab.
4. Within the Speed group, set the Acceleration slider to the exact
center position.
5. Within the Speed group, set the Sensitivity slider to low.
6. Within the Drag & Drop group, set the Threshold slider to small.
7. Click Close.
¾ To configure the video:
1. From Desktop Preferences, select Graphics Card and Monitor. The
Card and Monitor Properties dialog opens.
2. Verify that a Resolution and Refresh Rate is in use that is supported
by Dominion KX II. Please refer to Supported Video Resolutions for
more information.
Note: If you change video resolution, you must logout of the target server and
log back in for the video settings to take effect.