Raymarine C Series - Manual (Page 18)

4 C-Series Display Reference Manual
Waypoints (Chapter 3) & AIS (Chapter 11)
Whilst not applications in their own right, waypoints and AIS are handled at system
level and are covered in separate chapters.
1.3 The Simulator
The C-Series Display includes a simulator mode, which allows you to practice
operating your display without data from a GPS antenna, radar scanner, fishfinder or
AIS receiver. The simulator mode is switched on/off in the System Setup Menu (see
page 183 ). Once enabled, you can use the simulator:
• Before installation - Simply connect the display to a 12V DC power supply,
fused at 1 amp by attaching the red core from the power lead to positive (+) and
the black core to negative (-).
• After installation - Whilst in a marina or at anchor.
Please note that system settings made whilst in simulator mode, are not transmitted
via SeaTalk to other equipment.
Important: Incoming AIS safety messages cannot be displayed while the simulator is
switched on.
81221_4.book Page 4 Tuesday, February 28, 2006 5:24 PM