Raymarine C Series - Manual (Page 27)

Chapter 2: General Operation 13
2.6 Initial setup procedures
When you first use your C-Series Display after it has been commissioned (see
Installation Guide), we recommend that you carry out the following:
• Set the language, the date and time format and preferred units of measurement.
• Select a page set.
• Select an application page/window.
• Adjust the display lighting.
Note: For full details of all setup and customizing options, please refer to Chapter
12:System setup and customizing.
Setting the language, date/time format and units of mea-
surement
To adjust the language, date/time format and units of measurement to your preferred
settings:
1. Select the setting:
2. Adjust the setting:
3. Repeat this process until you have changed all of these settings.
Note: For full details of all System Setup options, please refer to Chapter 12:System set-
up and customizing. For application specific set up options, please refer to the appro-
priate chapter.
Setup
System Setup...
Alarm Setup...
System Setup Menu
Date/Time Setup...
Units Setup...
System Integration Setup...
Waypoint Password Setup...
Position Made Lat/Lon...
D8504-1
Highlight
System Setup
Enter System
Setup
Highlight required
setting
Enter setting
MENU
D8505-1
Change value as
required
OK
or
Time Format 12hr
Local Time Offset UTC
Date/Time Setup Menu
dd/mm/yy
mm/dd/yy Date Format mm/dd/yy
e.g.
81221_4.book Page 13 Tuesday, February 28, 2006 5:24 PM