Regency Panorama P36D - Manual (Page 53)

FPI P36D-1 Zero Clearance Direct Vent Gas Fireplace 53
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located
underneath the top of the fi rebox.
2) The bottom louver has a hinge that is
attached (2 screws per hinge) to the lip on
bottom of the unit.
3) Open the bottom louver. Pull the Burner
ON/OFF control box from inside the bottom
of the fi replace and position the slots in the
bracket over the 2 screws on the left side
of the bottom louver. Push down to lock into
place. Tighten the screws.
Burner ON/
OFF control
box attached
to bottom
fl ush louver.
Screws on
louver bracket
Burner ON/OFF
control box
FLUSH TRIM
Attach the round magnets to the back of the
top trim piece and to the bottom trim piece,
then attach trim to the top and bottom of Flush
door.
DOUBLE
SCREEN DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
fl ush door.
3) Open the screen door(s) and secure the
screen door to the fl ush door front with 2
clips on the bottom left and right side.
Clip locations
Clip installed on right side.
Note: Top and
bottom louvers are
different.
REGENCY ® OPTIONS