Ricoh AFICIO 1035 - Manual (Page 244)

REMARKS
230
6
Where to Put Your Machine
Machine Environment
Your machine's location should be
carefully chosen because environ-
mental conditions greatly affect its
performance.
Optimum environmental conditions
R CAUTION:
R CAUTION:
• Temperature: 10 – 32
°C (50 –
89.6
°F)(humidity to be 54% at
32
°C, 89.6°F)
• Humidity: 15 – 80% (temperature
to be 27
°C, 80.6°F at 80%)
• A strong and level base.
• The machine must be level within
5mm, 0.2" both front to rear and
left to right.
• To avoid possible buildup of
ozone, be sure to locate this ma-
chine in a large well ventilated
room that has an air turnover of
more than 30 m
3 /hr/person.
Environments to avoid
• Locations exposed to direct sun-
light or strong light (more than
1,500 lux).
• Locations directly exposed to cool
air from an air conditioner or heat-
ed air from a heater. (Sudden tem-
perature changes might cause
condensation within the machine.)
• Locations close to such machines
generating ammonia as diazo copy
machine.
• Places where the machine might be
subjected to frequent strong vibra-
tion.
• Dusty areas.
• Areas with corrosive gases.
Moving
R CAUTION:
Important
❒ If you move the machine, you
must be careful as follows:
• Turn off the main power
⇒ P.16
“Turning Off the Main Power”
• Unplug the power cord from the
wall. When you pull out the plug
from the socket, grip the plug to
avoid damaging the code and
causing fire or electric shock.
• Close the front cover, the by-
pass tray, or others.
• Keep the equipment away from
humidity and dust. Otherwise a
fire or an electric shock might oc-
cur.
• Do not place the equipment on
an unstable or tilted surface. If it
topples over, it could cause inju-
ry.
• If you use the equipment in a
confined space, make sure there
is a continuous air turnover.
• Unplug the power cord from the
wall outlet before you move the
equipment. While moving the
equipment, you should take care
that the power cord will not be
damaged under the equipment.
AdonisC2_AEcopy110F_FM.book Page 230 Wednesday, October 3, 2001 1:43 PM