Ricoh AFICIO 1035 - Manual (Page 246)

REMARKS
232
6
Maintaining Your Machine
If the exposure glass, platen cover, or
document feeder belt is dirty, you might
not be able to make copies as you want.
Clean them if you find them dirty.
❖ ❖ ❖ ❖ Cleaning the machine
Wipe the machine with a soft,
damp cloth. Then, wipe it with a
dry cloth to remove the water.
Important
❒ Do not use chemical cleaner or organ-
ic solvent, such as thinner or benzene.
If they get into the machine or melt
plastic parts, a failure might occur.
❒ Do not clean parts other than those
specified in this manual. Such
parts should be cleaned by your
service representative.
Cleaning the Exposure Glass
Clean 1 and 2
Cleaning the Platen Cover
Cleaning the Document Feeder
Clean 1 and 2
Changing the Photoconductor
Unit (PCU)
Only use the photoconductor unit
made for this machine. Follow the
procedure below to change unit.
Important
❒ Be sure to unplug the power cord
from the outlet before changing
the photoconductor unit.
A Open front door, duplex unit, and
then transfer unit right cover.
B Push the development unit to the
left, and then pull the photocon-
ductor unit out.
C Remove the harness clamps on the
charge unit and cleaning unit of
the new photoconductor unit.
D Push the development unit to the
left, and then install the new pho-
toconductor unit.
Note
❒ If the copy result is still not satis-
factory after replacing the photo-
co nducto r un it, co ntact your
service representative.
AdonisC2_AEcopy110F_FM.book Page 232 Wednesday, October 3, 2001 1:43 PM