Renesas Emulation Probe for M32C/88 Group M30880T-EPB - Manual (Page 48)

M30880T-EPB User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0497-0100Z Rev.1.00 January 16, 2005 Page 48 of 100
3. Usage (Emulator Debugger)
This chapter describes how to start up the emulator debugger and how to use the major windows.
3.1 Starting Up the Emulator Debugger (Init Dialog Box)
To launch the emulator debugger, click the Start menu of Windows and then select
Program (P) >> [RENESAS-TOOLS] >> [PD308F V.xx.xx Release x] >> [PD308F].
When the emulator debugger started up, the Init dialog box appears.
(1) MCU tab
1. Specifying the MCU file
2. Specifying the communication interface (LPT communication)
Specifying the MCU file
Click the “Refer...” button.
A file selection dialog box will be displayed, so select the
desired MCU file. The MCU file is stored in the directory in
which you installed the M3T-PD308F.
(Example: c:\mtool\PD308F\mcufiles)
- The MCU file contains the information specific to the
target MCU.
- The MCU file you have selected is displayed in the MCU
section of the MCU tab.
Specifying the communication interface
(LPT communication)
For selecting the LPT communication, click the radio button
“LPT” of the MCU tab. Specify the using LPT
communication mode at the Type area. Specify the I/O
address of the parallel port at the I/O address area. For BIOS
setup, the following addresses are available.
- 378h
- 278h