Renesas Emulation Probe for M32C/88 Group M30880T-EPB - Manual (Page 57)

M30880T-EPB User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0497-0100Z Rev.1.00 January 16, 2005 Page 57 of 100
(2) Emulation Memory tab
1. Setting the Bank Address of the Debug Monitor
IMPORTANT
Notes on Setting a Debug Monitor Bank Address:
It is not possible to view or set the content of the specified area. Even on the memory window or in the reverse
assemble area of the program/source windows, the content of this area is not displayed correctly though it can
be displayed.
The below bank addresses cannot be set for the debug monitor.
(1) MCU internal resources (ROM, RAM and SFR areas)
(2) Interrupt vector area
Setting the Bank Address of the Debug
Monitor
The debug monitor uses contiguous 64 KB as a work area of
the emulator. Specify the bank address of the debug
monitor.
(e.g.: If F0 is specified, 64 KB area from F00000H address
is used by the debug monitor)
Automatically Allocating the Emulation
Memory of the Internal ROM
When selecting the single-chip mode, an emulation memory
is automatically allocated to an internal ROM area. The
automatically allocated addresses of the internal ROM are
shown here.