Roland FC-300 - Manual (Page 12)

12
Introduction
Connecting an AC Adaptor
If you’re using a BOSS PSA series AC adaptor, here’s how to connect the cord and
secure it on the cord hook.
fig.CordHook.j.eps
fig.
* Power is supplied from the RRC2 IN device, so no batteries or AC adaptor is necessary.
* If using commercially available ethernet cable as the RRC2 connecting cable, be sure that
the cable meets the following specifications.
• Category 5 (Cat5) or above
• Maximum length of 15 meters
• Cable designed for straight-through connections
Connections To Make When Using the FC-300 as a
Dedicated Foot Controller for an RRC2 IN Device
(e.g., the VG-99)
Cord Hook
The cord of
the supplied AC Adaptor
To the Power Outlet
925
Use only the specified
expression pedal (Roland EV-
5, BOSS FV-500L/FV-500H;
each sold separately). By
connecting any other
expression pedals, you risk
causing malfunction and/or
damage to the unit.
Carefully connect the RRC2
cable or Ether cable all the way
in—until it is firmly to the
RRC2 connector.
Ethernet cables designed for
crossover connections cannot
be used.
Do not subject the RRC2 cable
and the Ether cable to stress or
physical shock.
PCS-31 PCS-31
Connect to footswitch jack
RRC2 cable
RRC2 IN device
EV-5 etc.
Guitar Amp etc.
BOSS
FS-6
BOSS
FS-5U
BOSS
FS-5U
BOSS
FS-5U
White Red White Red
FC-300_e1.book 12 ページ ２００７年４月２４日 火曜日 午前１０時１０分