Roland FC-300 - Manual (Page 48)

48
Other Features
1
Press PARAMETER [ ] [ ] to select “SYS:Bnk Chg Mode.”
2
Press the VALUE [ ] [ ] to program the settings.
Here are some examples of operation in Standard Mode.
3
When you’ve finished making the settings, press [UTILITY] or [EXIT].
You can set an upper limit on the banks that can be switched, thus limiting the range
of banks that are switched and allowing you to select only the patches required.
1
Press PARAMETER [ ] [ ] to select “SYS:Bank Extent.”
2
Press VALUE [ ] [ ] to set the upper limit on the banks.
3
When you’ve finished making the settings, press [UTILITY] or [EXIT].
Using the [ ] [ ] Pedals to Make the Settings
Value Explanation
IMMEDIATE Program changes are transmitted immediately when [ ] or
[ ] is pressed.
Example) When starting from “003,” pressing [ ] simulta-
neously transmits PC#8.
WAIT FOR A NUM Program changes are transmitted when a number pedal is
pressed after [
] or [ ] is pressed.
Example) Starting from “003,” after [ ] is pressed and all of the
green number pedal indicators are flashing, pressing number
pedal 8 outputs PC#8.
RESET NUMBER Although program changes are transmitted immediately when
[
] or [ ] is pressed, just as with Immediate, in this case, the
number furthest to the left is output.
Example) If starting from “003,” pressing [
] simultaneously
transmits PC#6.
Limiting the Range of Banks That Can Be Switched
(Bank Extent)
This is enabled only when PC
Mode is set to EFFECTS.
FC-300_e1.book 48 ページ ２００７年４月２４日 火曜日 午前１０時１０分