Roland FC-300 User Manual
Page 35
35
Patch Mode
When Setting Channel Messages and Realtime Messages
1
Press PARAMETER [
] [
] to move the cursor to the MIDI message.
2
Press VALUE [
] [
] to select the MIDI message to be edited.
3
Press PARAMETER [
] [
] to move the cursor to the parameter you want
to change.
4
Press VALUE [
] [
] to change the value.
If there is any other message you want to change, select the message number as
instructed in Step 4 of
(p. 34), then repeat Steps 1-4.
5
After making the changes, follow the instructions in “Storing (Saving)
Patches” (p. 44) to save the MIDI messages to a patch.
MIDI Message
Data
PC
MIDI Channel (CH#), Program Number (PC#)
CC
MIDI Channel (CH#), Controller Number (CC#), Value (VAL)
N.ON
MIDI Channel (CH#), Note Number (NOTE#), Velocity (V)
N.OFF
MIDI Channel (CH#), Note Number (NOTE#), Velocity (V)
C.PRS
MIDI Channel (CH#), VALUE
K.PRS
MIDI Channel (CH#), Note Number (NOTE#), Velocity (V)
P.BEND
MIDI Channel (CH#), Value (MSB, LSB)
REALTIME
MIDI START/MIDI STOP/MIDI CONTINUE
When the MIDI channel is set
to Tx, the channel set with the
MIDI:Tx Channel parameter in
Utilities is set (p. 52).
Data
Message Number
MIDI Message
MIDI Channel
FC-300_e1.book 35 ページ ２００７年４月２４日 火曜日 午前１０時１０分