Roland FC-300 - Manual (Page 21)

21
Control Change Mode
This is the mode for sending Control Change messages.
In this mode, all the pedals can be used to send Control Change messages. You
should use this mode at times when you want to send a lot of Control Change
messages.
You can also store up to five sets, or configurations, of settings for all of the pedals
within the FC-300’s memory. Called pedal settings, these configurations can be
switched as needed (p. 26).
Pressing the various pedals transmits the Control Change messages set for the
respective pedal over the selected MIDI channel.
Control Change messages with the controller numbers set for each pedal are
transmitted.
Each pedal is set at the factory as shown below.
These switch the number pedal functions.
About the Control Change Mode
Transmitting Control Change Messages
Number Pedal (1/6–5/10)
Pedal CC# Range Mode Pedal CC# Range Mode
1 65 0–127 LATCH 6 70 0–127 LATCH
2 66 0–127 LATCH 7 71 0–127 LATCH
3 67 0–127 LATCH 8 72 0–127 LATCH
4 68 0–127 LATCH 9 73 0–127 LATCH
5 69 0–127 LATCH 10 74 0–127 LATCH
[ ] [ ] Pedal
Pedal Explanation
[ ] This sets the number pedals to function as pedals 1–5.
[ ] This sets the number pedals to function as pedals 6–10.
Pedal Setting Number
For details about the all
parameters and changes the
setting, refer to “Change the
Pedal Settings”
(p. 24).
When the [ ] pedal is pressed, the [ ] pedal’s indicator lights, and the functions
for number pedals 1–5 become operable.
When the [ ] pedal is pressed, the [ ] pedal’s indicator lights, and the functions
for number pedals 6–10 become operable.
FC-300_e1.book 21 ページ ２００７年４月２４日 火曜日 午前１０時１０分