Roland FC-300 - Manual (Page 25)

25
Control Change Mode
Range
This sets the range for values that are transmitted.
fig.05-009
Mode
This sets the switch mode.
fig.05-009
AMP Ctl Op (Amp Control Operation)
This selects whether or not the AMP CONTROL jack is to be controlled.
fig.05-009
When the AMP Ctl Op parameter is set to ON and the AMP Polarity parameter is set
to Normal, control of AMP CONTROL with the pedal functions as shown below.
fig.05-00fig.05-009
4
When you have finished with the editing, press [EXIT].
The top screen appears.
5
After making the changes, follow the instructions in “Storing Controller
Numbers Assigned to the Pedals (Pedal Settings)” (p. 26) to save the settings.
Value Explanation
LATCH The ON and OFF will alternate each time you press the pedal.
MOMENTARY The value will be ON while you press the pedal, and OFF when you re-
lease the pedal.
Minimum Maximum
The Range parameter is
enabled when CC#, P.BEND,
or CH.PRS is selected for the
expression pedal.
The Mode parameter and AMP
Ctl Op parameter are enabled
when a control pedal or other
switch function is selected.
AMP CONTROL
1 jack
AMP CONTROL
2 jack
When the pedal is OFF
When the pedal is ON Open
Guitar Amp
(amps channel switching jack)
FC-300
(AMP CONTROL jack)
Guitar Amp
(amps channel switching jack)
FC-300
(AMP CONTROL jack)
Closed
The settings made for the
pedals are lost when the pedal
settings are switched. To save
settings made for the pedals,
save them as pedal settings.
For more detailed information,
see “Storing Controller
Numbers Assigned to the
Pedals (Pedal Settings)” (p.
26).
You can change the polarity of
the AMP CONTROL jacks. For
more detailed information, see
“Setting the Polarity of the
AMP CONTROL Jacks” (p.
50).
FC-300_e1.book 25 ページ ２００７年４月２４日 火曜日 午前１０時１０分