Roland FC-300 - Manual (Page 22)

22
Control Change Mode
In keeping with the movement of the expression pedal, Control Change messages
with the controller numbers set for each pedal are transmitted consecutively.
Each pedal is set at the factory as shown below.
Control Change messages with the controller numbers set for each pedal are
transmitted.
Each pedal is set at the factory as shown below.
Using the Expression Pedals
Expression Pedal CC# Range
EXP PEDAL 1 7 0–127
EXP PEDAL 2 1 0–127
Using the Control Pedal and Expression Pedal Switch
Pedal CC# Range Mode
CTL PEDAL 1 80 0–127 LATCH
CTL PEDAL 2 81 0–127 LATCH
EXP PEDAL SW 1 82 0–127 LATCH
EXP PEDAL SW 2 83 0–127 LATCH
For details about the all
parameters and changes the
setting, refer to “Change the
Pedal Settings”
(p. 24).
The Control pedal is a
momentary type pedal that
sends an ON message when
depressed and an OFF
message when released. You
can change this to latch type
operation, which sends an ON
or OFF message each time you
depress it – see “Mode” (p. 25).
You can use the control pedal
and expression pedal switch to
switch the AMP CONTROL
jacks – see “Change the Pedal
Settings”
(p. 24).
FC-300_e1.book 22 ページ ２００７年４月２４日 火曜日 午前１０時１０分