Setting up an oracle connect adapter – Oracle Audio Technologies B31003-01 User Manual

Page 67

Advertising
background image

Configuring Oracle Connect

Installing and Configuring OracleAS Adapter for IMS/TM 6-19

7.

Enter the name and password used to access the computer and confirm the
password.

8.

Click OK.

Modeling Interactions for OracleAS Adapter for IMS/TM

Modeling interactions for OracleAS Adapter for IMS/TM involves defining an Oracle
Connect back-end adapter using Oracle Studio. All the definitions specified in Oracle
Studio are written to the IBM OS/390 or z/OS platform.

This section contains the following topics:

Setting Up an Oracle Connect Adapter

Generating Outbound Interactions

Setting Up an Oracle Connect Adapter

To work with the Oracle Connect, you need to set up an adapter definition on the IBM
OS/390 or z/OS platform to handle the interactions to and from an IMS/TM
transaction. You use Oracle Studio to specify these definitions.

Perform the following steps:

1.

From the Start menu, select Programs, Oracle, and then select Studio.

2.

In the Configuration Explorer, expand the node of the computer defined in

"Setting Up the IBM OS/390 or z/OS Platform in Oracle Studio"

on page 6-14.

3.

Expand the Bindings node. The binding configurations available on this computer
are listed.

4.

Expand the NAV binding node. The NAV binding configuration includes branches
for data sources and adapters that are located on the computer.

5.

Right-click Adapters and select New Adapter to open the New Adapter wizard.

6.

Enter a name for the back-end adapter.

7.

Select IMS/TM as the back-end adapter type from the Type list as shown in the
following figure:

Note:

The word event is a reserved word and cannot be used

when naming an adapter.

Advertising