Oki B4100 - Manual (Page 101)

40055101TH Rev.4 101 /
Table 2.9.3 (4/6) User's Functions
No. Item Specifications
The fax can temporarily store received messages in memory when
toner has run out. The messages are printed when toner has been
newly supplied or an operator presses the SELECT FUNCTION
key followed by the one-touch key No. 10 under the LCD message
“MSG. IN MEMORY/REPLACE TONER CART.” in the standby
mode.
* TF + 06 (To enable or disable this function)
The documents received in the STD mode can be printed at the
FINE resolution by means of generating one line based on the two
consecutive original lines and printing it between them.
The documents for transmission can be read into the memory even
while the fax is engaged in another memory transmission, reception
in the ECM or non-ECM mode.
1) Operation of memory transmission while the fax is engaged in
a communication (memory TX, memory RX or print mode
RX).
2) Copy while the fax is engaged in a communication (memory TX
or memory RX).
Note: Condition for operation
a) Copy is invalid when the machine is already engaged in an
operation which is using or could use the printer.
3) Call reception while the fax is engaged in scanning documents
for memory transmission when the auto receive mode is in
“FAX” or “T/F” mode, although “TEL” mode is not valid.
Refer to sub-section 2.9.7 for dual access operation.
For the patterns of dual access refer to the following, Dual Access
Combination Table.
17 No toner reception
18 Smooth printing
19 Dual Access
(except OKIOFFICE44/
OKIFAX 4100)
Rev. 3