Oce North America TDS600 - Manual (Page 148)

148 Océ TDS600 Multifunctional Digital System User Manual
■ System status (icon for connected or disconnected)
The following icons are used:
The Settings Editor is connected to a system.
The Settings Editor is disconnected from a system.
■
System name (‘localhost’ if you are working at the controller)
■
User mode (Repro operator, Key operator, System administrator or
anonymous)
■ View mode (KO settings or SA settings).
How to access the Settings Editor
In order to perform special key operator functions, you must log into the
Settings Editor
as a key operator.
As these functions are restricted to a dedicated key operator, a password is
required to access them. The service engineer will provide this password to
you upon installation.
Note: Only one key operator or system administrator at a time is authorised to
make modifications. However, there may be multiple users viewing the settings.
When a second user tries to log in as Key Operator or as System Administrator,
an error message is displayed.
Start Océ Settings Editor
You can start the Océ TDS applications on the controller as well as on a remote
workstation.
▼ ▼ ▼ ▼ Start Océ Settings Editor on the Power Logic Controller
1 Select the 'Launcher' application.
2 Select Settings Editor. Océ Settings Editor starts.
▼ ▼ ▼ ▼ Start Océ Settings Editor on a remote workstation
Note: You must first install Remote Logic as described (see ‘Installation
procedure for MS Windows systems’ on page 111).
1 Select 'Océ Remote Logic' via the 'Start' menu.