Oce North America TDS600 - Manual (Page 245)

Media and supplies 245
8 Use both hands to place the holder in the roll loader (see figure 132).
d
[132] Placing the new roll in the roll loader
9 Place the holder back in the roll compartment by returning the roll loader lever
to its upright position. The roll will now be loaded.
Caution: Be careful when lifting the lever to avoid any possible damage to
the roll compartment.
10 Use both hands to slide the material under the metal paper guide until it makes
contact, as described in the procedure for loading rolls of print material.
11 Press the appropriate green button inside the roll compartment. The material
will automatically be fed into the machine.
Note: Also refer to the sticker inside the drawer.
12 Press the green button a second time to cut off the material protruding from the
paper path.
13 Remove the scrap material.
14 Return the roll loader lever to its starting position by pushing it to the left.
15 Close the paper roll compartment.
16 Press the on line button to put the system off line.
17 Specify the size and type of material on the operating panel.
18 Press the on line button again.
Note: When you alter the size and/or media type, you have to adjust the settings
on the operating panel.