Oki 5400 - Manual (Page 74)

66 User’s Guide
Note:
Depending on local telephone regulations, some of
the following user function settings may not be
available.
User function settings list
01:MCF (SINGLE-LOC.): This function automati-cally prints a
Message Confirmation Report after each single location transmission or
polling transmission. Available settings are on and off.
02:MCF (MULTI-LOC.): This function automatically prints a Message
Confirmation Report after each multiple location transmission. Available
settings are on and off.
03:ERR REPORT (MCF): This function automatically prints a Message
Confirmation Report each time an error occurs during a transmission or
polling reception operation. Available settings are on and off.
04:IMAGE IN MCF: When a Message Confirmation Report is
automatically printed, this function adds a portion of the first page your fax
machine transmitted. This is printed at the bottom of the message
confirmation report. Available settings are on and off.
05:SENDER ID: This function controls the printing of the Sender ID of
your fax machine on the faxes you send. When turned on, your Sender ID
will be printed on each page slightly outside the image area of your
document. When turned off, your Sender ID will not be printed.
06:MONITOR VOLUME: This function sets the volume your fax
machine uses for telephone line monitoring sounds during dialling.
Available settings are low, high and off.
07:BUZZER VOLUME: This function sets the volume of the various
beep and alarm tones your fax machine emits during operations. Available
settings are low, middle and high.
08:CLOSED NETWORK: This function allows you to program your fax
machine to refuse to receive faxes from or transmit faxes to locations
whose telephone numbers have not been programmed into the One Touch
keys or Auto Dial numbers of your fax machine. Using this function, you
can set up a closed network of fax machines. If you do not want your fax
machine to transmit faxes to or receive faxes from locations outside your
network, select T/R. If you only want your fax machine to refuse to receive
faxes from outside your network, select RX. Available settings are OFF,
T/R and RX.