Quantum Sun StorEdge L100 - Manual (Page 116)

Chapter 6 Running the Demonstration Programs
Running the Demo 2 Program
100 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
Running the Demo 2 Program
6
The Demo 2 program causes the robot to pick a cartridge from the
first occupied magazine slot and place it in the next vacant
magazine slot. The robot then moves to the next occupied slot and
repeats the process.
To run the
Demo 2 program:
1 Verify that at least one magazine is installed in the library and
that at least one cartridge is present.
2 Access the Demo Programs screen (see Accessing the Demo
Programs Screen ).
3 Press the Up or Down buttons to select Demo 2 .
4 Press Select .
The Demo 2 program starts. This program continues until you
press the Stop button.
5 If desired, include the drives or the fixed slot in the test:
a Press the Level button to select the level where the desired
drive or fixed slot is located.
b Press Drive 1 or Drive 2 to include a drive.
c Press Fixed to include the fixed slot.
6 To stop the program, press Stop .
The GUI displays a status screen listing the demonstration
program number, the number of cycles completed, and the
status of the test: pass or fail.
7 Press Back to return to the Demo Programs screen.