Quantum Sun StorEdge L100 - Manual (Page 75)

Chapter 3 Changing the Library Configuration
Changing the Emulation Setting
Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide 59
Changing the Emulation Setting
3
The Emulation option allows you to set the library to act as either a
Quantum ATL library or an M4 Data library.
To set the emulation:
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Emulation is highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Emulation
setting. The available settings are ATL M2500 , ATL 1500 , and
M4 Data .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting for the L25 is M4 Data ; the default
setting for the L100 is ATL M2500 .
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.