Quantum Sun StorEdge L100 - Manual (Page 74)

Chapter 3 Changing the Library Configuration
Changing the Terminator Power Setting
58 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
Changing the Terminator Power Setting
3
The Terminator Power option controls whether the library robotics
provide terminator power.
To enable or disable robotics terminator power:
1 Access the Configuration screen (see Accessing the
Configuration Screen ).
2 Press the Up or Down buttons until Terminator Power is
highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired Terminator
Power setting. Available settings are Enabled and Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Note: The default setting is Enabled .
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.