Quantum 10K II - Manual (Page 254)

SCSI Description
Quantum Atlas 10K II Ultra160/m SCSI Hard Disk Drives 5–187
REQUEST SENSE Command (03h) (continued)
Table 5–86 Supported Additional Sense Codes and Sense Code Qualifiers (continued)
Sense Key Code Qualifier Meaning
06h UNIT ATTENTION
(continued)
29 03 Bus Device Reset Occurred
29 04 Device Reset Occurred, Bugcheck
Occurred
29 05 Bus Mode Changed to Single-Ended
29 06 Bus Mode Changed to LVDS
29 86 Commands Aborted, ACK Overrun
Detected
2A 01 Mode Parameters Changed
2A 02 Log Parameters Changed
2A 03 Persistent Reservations Were Cleared
2F 00 Commands Aborted by Another Initiator
3F 01 Target Operating Condition Changed,
Microcode has Changed
5C 01 Spindle Sync’d
5C 02 Spindle Not Sync’d
5D 00 SMART Tripped
5D 01 TA Error Rate Threshold Exceeded
5D 02 READ or WRITE Error Rate Thresh. Exceeded
5D 0B SMART Triggered Due to Spin Retry
5D FF SMART Test Trip
07h DATA PROTECT 27 00 Unit Hardware or Firmware Write
Protected
09h VENDOR UNIQUE 81 00 Read Overlaps Deferred Write
0Bh ABORTED COMMAND 00 00 No Additional Sense Information Error
25 00 Logical Unit Not Supported
41 00 Data Path Failure
41 86 Commands Aborted, ACK Overrun
Detected*
43 00 Message Reject Error
44 00 Busy Timeout
45 00 Selection or Reselection Failure
47 00 SCSI Bus Parity Error Detected
48 00 Initiator Detected Error (IDE) Message
Received
48 86 ACK Overrun Detected Error
49 00 Invalid Message Error
4E 00 Overlapped Commands Attempted
0Eh MISCOMPARE 1E 00 No Additional Information